7757-K011 Cable Management Bar

Introduction

This kit provides a Cable Management Bar to secure peripheral cables connected to the NCR Columbus 900 POS.

Kit Contents

Cable Management Bar (7757-K011)
	Part Number	Description
1	497-0481392	Columbus Cable Management Bar

Installation Procedure

1.Tilt the Display backward.

2.Slide the Front Cover upward to remove it from the stand.

3.Mount the Cable Management Bar on the base, pushing the extra length of peripheral cables towards the rear side.

Note:  Make sure that the PSU cable ferrite bead rests on the management bar and not pushed to the rear side of the stand.

4.Secure the management bar using two thumbscrews.

5.Install the Front Cover to the stand.
Insert the two tabs of the cover to the slots on the base of the stand and then rotate the upper part of the cover until it snaps, secured to the stand.